TiLite Rigid TR Series Owner's Manual page 74

axle sleeves until these two measurements are
equal.
13. Measure the distance from the seat tube to the
inside of the tire at the front of each tire on both
sides of the frame ("Measurement B").
85.
14. If Measurement B is the same on both sides of the
chair, proceed to step 17.
15. If Measurement B is not the same on both sides of
the chair, you will need to rotate the camber plugs in
the axle sleeve mounts as necessary to make sure
Measurement B is equal on both sides of the chair.
Make sure when you rotate the camber plugs, you
do not affect the rear wheel spacing. See "Adjusting
Rear Wheel Spacing" on
16. After adjusting the camber plugs in step 15, it will be
necessary to recheck the toe-in/toe-out. See steps 6
through 10 above.
17. Securely tighten the Allen Screws in the axle sleeve
mounts. See Figure 82.
66
See Figure
pages 64-65.
(here's two versions, pick one or the other)
Measurement B
(here's two versions, pick one or the other)
Toe-In/Toe-Out
Toe-In/Toe-Out Measurement
Measurement
Figure 84
Adjusting Toe-In/Toe-Out
Measurement B
Figure 85
Adjusting Toe-In/Toe-Out
TiLite ® OM000007 - Rev. B
Measurement B