Repositioning The Handle For Your Uni-Lock Wheel Lock; Standard Handle Positions 1, 2, 3 - TiLite Rigid TR Series Owner's Manual

Allen Screws
Figure 96
Removing the Wheel Lock Handle
Pull to Unlock
Figure 97
Standard Handle Positions 1, 2 and 3 Locked
Figure 98
Standard Handle Positions 1, 2 and 3 Unlocked
TiLite ® OM000007 - Rev. B
Repositioning The Handle For Your Uni-
Handle
Lock Wheel Lock
Six (6) handle positions are achievable using the Uni-
Lock. See Figures 97 through 100. Each handle
position can be used as either a Pull to Lock or a
Push to Lock (see "Changing the Uni-Lock From the
Push to the Pull Position" on
Base
possible Uni-Lock setups.
Figures 97 through 100 show the handle in both the
engaged (locked) and disengaged (unlocked)
positions. Study the Figures to determine which
handle configuration will work best for you. Follow the
directions below to reconfigure your handle to the
desired configuration.

Standard Handle Positions 1, 2, 3

Your Uni-Lock is shipped by TiLite with the handle in
1
standard position 3. If you desire to switch to standard
2
positions 1 or 2, follow the procedures below.
Tools Needed:
• 1/8" Allen Wrench
3
• 3/8" Open End Wrench
1. As shown in Figure 96, the wheel lock handle
attaches to the wheel lock handle base with two
Allen Screws. There is only one hole in the wheel
lock handle base through which to attach the upper
Allen Screw. There are three holes in the wheel lock
handle base through which to attach the lower Allen
Screw.
2. Remove the lower Allen Screw and nut that secure
the wheel lock handle to the wheel lock handle
base.
3. Loosen, but do not remove, the upper Allen Screw
that secures the wheel lock handle to the wheel lock
handle base.
4. Reposition the wheel lock handle to the desired
Standard Handle Position 1, 2 or 3 (see Figures 97
and 98) and replace the Allen Screw and nut.
5. Securely tighten both Allen Screws and nuts.
page 72), resulting in 12
73