Chapter 13: Anti-Tips; Rear Anti-Tips; Adjusting; Mounting - TiLite TRA AERO T Owner's Manual

Hide thumbs

Table Of Contents

100

Table of Contents

Rear Anti-Tips

Adjusting

1. The bottom of the anti-tip wheels should be between 1-1/2" and 2" above the floor to ensure proper functionality.

To adjust the height, press the two release buttons on the telescoping lower tube, then adjust the height of the

lower tube. See Figure 13-1.

2. To rotate the anti-tips upward, press the release button at the top of the extension tube to release the extension

tube and rotate upward until the release button locks in place on the opposite side of the anti-tip receiver.

3. To remove the anti-tip, press the release button at the top of the extension tube and pull the extension tube out of

the anti-tip receiver.

Mounting

I WARNING

Only an authorized TiLite dealer or qualified technician should install the rear anti-tip receiver. If you ignore this

Warning, you may fall, tip over or lose control of the wheelchair and seriously injure yourself or others or damage the

wheelchair.

Tools Needed:

•

5/32" Allen Wrench

•

3/16" Allen Wrench

•

7/16" Open End Wrench

1. Remove the rear wheels and place the frame on a level surface.

2. Remove the camber tube. See "Replacing the Camber Tube" on page 8-3.

3. Thread the Allen screw through the right side camber mount, right side anti-tip receiver and the washer and

securely tighten the nylock nut. See Figure 13-2.

Note: Make sure that the anti-tip receiver is oriented to be parallel to the floor.

5. Repeat Step 3 on the left side camber mount and the left side anti-tip receiver.

6. Reinstall the camber tube. See "Replacing the Camber Tube" on page 8-3.

7. Tighten the Allen screw in each anti-tip receiver so that it securely clamps into the camber tube.

8. Reinstall the rear wheels.

Aero T/TRA Owner's Manual

Figure 13-1

Adjusting

Receiver

Release

Button

Release

Button

13-1