D41Jctlsew Analog Port Board Diagram - Avaya S8800 Maintaining

Procedure
1. Set the unique board ID of the new board. Turn the SW30 rotary switch, located on the top of
the board, to set the board ID according to the slot in which you are installing it. See the
following table.
Note:
If you are replacing an existing board, verify that the ID of the new board matches the ID
of the board that you removed by comparing the old board with the new board.
Board ID number
0
2. Set the hook-switch state of the new board to ON so that callers hear a busy signal when the
board is not initialized. Use the red SW4 switch, located near the top of the board, to set the
hook-switch state. For more information on how to set the on-hook switch, see Message
Networking Maintenance guide.

D41JCTLSEW analog port board diagram

The 4-port D41JCTLSEW analog port board is supported on the S8800 2U server.
May 2014
PCIe slot number for an S8800 2U server
1
Maintaining the Avaya S8800 2U Server for Message Networking
Comments? infodev@avaya.com
Dialogic port board settings
37