Avaya S8800 Maintaining page 66

2u server for message networking
Hide thumbs Also See for S8800:
Table of Contents

Advertisement

Replacing a power supply
2. If the server is in a rack, at the back of the server, pull back the cable management arm to
gain access to the rear of the server and the power supply.
3. Press and hold the orange release tab to the left. See the following figure.
1
2
4. Pull the power supply part of the way out of the bay, and then release the latch and support
the power supply as you pull the power supply the rest of the way out of the bay.
Next steps
Install a power supply.
Maintaining the Avaya S8800 2U Server for Message Networking
66
Power supply
Power supply release tab
Comments? infodev@avaya.com
May 2014

Advertisement

Table of Contents
loading

Table of Contents