Mazda CX-30 2020 Owner's Manual page 547

2. Tyre valve
Damage could occur during
installation if the wheel cover is not
properly aligned.
2. Loosen the wheel nuts by turning
them anticlockwise one turn each,
but do not remove any wheel nuts
until the tyre has been raised off the
ground.
3. Place the jack on the ground.
4. Turn the jack screw in the direction
shown in the figure and adjust the
jack head so that it is close to the
jack-up position.
1. Jack head
5. Place the jack under the jack-up
position closest to the tyre being
changed with the jack head
squarely under the jack-up point.
1. Jacking position
6. Continue raising the jack head
gradually by rotating the screw with
your hand until the jack head is
inserted into the jack-up position.
1. Tyre blocks
2. Jacking position
If Trouble Arises
Flat Tyre
7-35