Mazda CX-30 2020 Owner's Manual page 316

When Driving
i-ACTIVSENSE
WARNING
Always verify the safety of the
surrounding area when setting the
ASL:
If the speed is set lower than the
current vehicle speed, the vehicle
speed is decreased to the set speed.
Verify the safety of the surrounding
area and keep a safer distance
between vehicles ahead and behind
you.
1. Press the LIM switch to turn the
system on.
2. Press the RES switch up (SET+) or
down (SET-) to set the speed.
When the current vehicle speed is
30 km/h (19 mph) or more, the
speed is set to the current vehicle
speed. When the current vehicle
speed is less than 30 km/h (19
mph), the speed is set to 30 km/h
(19 mph).
3. To increase the set speed, press the
RES switch up (SET+) continuously.
The set speed can be adjusted in 10
km/h (5 mph) increments. The set
speed can also be adjusted in
about 1 km/h (1 mph) increments
by pressing the RES switch up (SET
+) momentary. For example, the set
speed increases about 4 km/h (4
mph) by pressing the RES switch up
(SET+) 4 times.
4. To decrease the set speed, press the
RES down (SET-) continuously. The
set speed can be adjusted in 10
km/h (5 mph) increments. The set
speed can also be adjusted in
about 1 km/h (1 mph) increments
by pressing the RES down (SET-)
momentary. For example, the set
speed decreases about 4 km/h (4
mph) by pressing the RES down
(SET-) 4 times.
4-168
NOTE
When the vehicle set speed is

displayed in the instrument cluster,
press the RES switch to set the
displayed vehicle speed.
The system is temporarily cancelled

when the vehicle is accelerated by
depressing the accelerator pedal
strongly, however, it resumes when
the vehicle speed decreases to the
set speed or less.
The vehicle speed may exceed the

set speed on a down slope.
In the following cases, the system

cannot be set.
Any door is open.

The driver's seat belt is unfastened.

▼ Temporarily Cancelling the System
The system is temporarily cancelled
(stand-by status) when any of the
following operations is done while the
ASL is displayed.
CANCEL switch is pressed

Accelerator pedal is strongly

depressed
Any door is opened

The driver's seat belt is unfastened

Press the RES switch to resume the
operation at the previous set speed.
The ASL display remains displayed.
NOTE
The set speed can be set by pressing

the RES switch up (SET+) or down
(SET-) while the system is in stand-by
status.
The ASL is not cancelled by

depressing the brake pedal.