Mazda CX-30 2020 Owner's Manual page 250

When Driving
i-ACTIVSENSE
When there are other sources of light

in the area such as street lamps,
illuminated signboards, and traffic
signals.
When there are reflective objects in

the surrounding area such as
reflective plates and signs.
When visibility is reduced under rain,

snow and foggy conditions.
When driving on roads with sharp

curves or undulations.
When the headlights/rear lamps of

vehicles ahead or in the opposite
lane are dim or not illuminated.
When there is insufficient darkness

such as at dawn or dusk.
When the luggage compartment is

loaded with heavy objects or the rear
passenger seats are occupied.
When visibility is reduced due to a

vehicle ahead spraying water from its
tyres onto your windscreen.
▼ To Operate the System
The ALH operates to control Glare-Free
High Beam, Wide-Range Low Beam
and Highway Mode automatically after
the ignition is switched ON and the
headlight switch is in the
low beam position.
The ALH determines that it is dark
based on the brightness of the
surrounding area. At the same time,
the ALH indicator light (green) in the
instrument cluster illuminates.
NOTE
Operation of the ALH function can be
disabled.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
4-102
▼ Manual Switching
Switching to low beams
Switch the headlight switch to the
position, or press the ALH switch.
The ALH indicator light (green) turns
off.
1. ALH switch
If the ALH is turned off using the ALH
switch, press the ALH switch again to
turn the ALH back on.
Switching to high beams
Shift the lever to the high beam
position.
The ALH indicator light (green) turns
and
off and the headlight high-beam
indicator light is illuminated.