246
4-5. Using the driving support systems
tance control mode does not function
correctly due to a dirty radar sensor,
etc.
1
With the cruise control off, press
and hold the cruise control main
switch for 1.5 seconds or more.
Immediately after the switch is pressed, the
radar cruise control indicator will come on.
Afterwards, it switches to the cruise con-
trol indicator.
Switching to constant speed control mode
is only possible when operating the switch
with the cruise control off.
2
Accelerate or decelerate, with
accelerator pedal operation, to the
desired vehicle speed (at or above
approximately 40 km/h [25 mph])
and press the "-SET" switch to set
the speed.
Cruise control "SET" indicator will come
on.
The vehicle speed at the moment the
switch is released becomes the set speed.
Adjusting the speed setting: P.243
Canceling and resuming the speed setting:
P.245
■
Dynamic radar cruise control can be set
when
The shift position is in D.
●
●
LC500: Range 4 or higher of D has been
selected by using the paddle shift switch.
●
Vehicle speed is at or above approxi-
mately 50 km/h (30 mph).
■
Accelerating after setting the vehicle
speed
The vehicle can accelerate by operating the
accelerator pedal. After accelerating, the
set speed resumes. However, during vehi-
cle-to-vehicle distance control mode, the
vehicle speed may decrease below the set
speed in order to maintain the distance to
the preceding vehicle.
Automatic cancelation of vehicle-to-
■
vehicle distance control mode
Vehicle-to-vehicle distance control mode is
automatically canceled in the following situ-
ations.
Actual vehicle speed falls at or below
●
approximately 40 km/h (25 mph).
VSC is activated.
●
●
TRC is activated for a period of time.
When the VSC or TRC system is turned
●
off.
●
When snow mode is set.
The sensor cannot detect correctly
●
because it is covered in some way.
Pre-collision braking is activated.
●
If vehicle-to-vehicle distance control mode
is automatically canceled for any other rea-