Table of Contents
Advertisement
Situation
The trunk was closed
while the electronic key
was still inside the trunk
and both side doors
were locked.
An attempt was made to
lock the vehicle while a
door was open.
●
When an interior alarm sounds continu-
ously
Situation
The engine switch
<power switch> was
turned to ACCES-
SORY mode while the
driver's door was open
(or the driver's door was
opened while the
engine switch <power
switch> was in ACCES-
SORY mode).
The engine switch
<power switch> was
turned off while the
driver's door was open.
If "Key Detected in Vehicle" is shown on
■
the multi-information display
An attempt was made to lock the doors
using the smart entry & start system while
the electronic key was still inside the vehi-
cle. Retrieve the electronic key from the
vehicle and lock the doors again.
Battery-saving function
■
The battery-saving function will be acti-
vated in order to prevent the electronic key
battery and the 12-volt battery from being
discharged while the vehicle is not in opera-
tion for a long time.
3-2. Opening, closing and locking the doors and trunk
In the following situations, the smart entry
●
Correction pro-
& start system may take some time to
cedure
unlock the doors.
• The electronic key has been left within
Retrieve the
approximately 2 m (6 ft.) of the outside of
electronic key
the vehicle for 10 minutes or longer.
from the trunk
• The smart entry & start system has not
and close the
been used for 5 days or longer.
trunk lid.
●
If the smart entry & start system has not
been used for 14 days or longer, the
Close both side
doors cannot be unlocked at the passen-
doors and lock
ger door. In this case, push the depres-
the doors again.
sion on the front edge of the driver's door
handle, or use the wireless remote con-
trol or mechanical key, to unlock the
doors.
Turning an electronic key to battery-
■
Correction pro-
saving mode
cedure
When battery-saving mode is set, battery
depletion is minimized by stopping the elec-
tronic key from receiving radio waves.
Press
Turn the engine
switch <power
holding
switch> off and
tronic key indicator flashes 4 times.
While the battery-saving mode is set, the
close the driver's
smart entry & start system cannot be used.
door.
To cancel the function, press any of the elec-
tronic key buttons.
Close the
driver's door.
■
Conditions affecting operation
The smart entry & start system uses weak
radio waves. In the following situations, the
communication between the electronic key
and the vehicle may be affected, preventing
the smart entry & start system, wireless
remote control and engine immobilizer sys-
tem <immobilizer system> from operating
properly. (Ways of coping: P.404)
When the electronic key battery is
●
depleted
twice while pressing and
. Confirm that the elec-
129
3
Advertisement
Table of Contents
