Stopping the engine
1
Stop the vehicle completely.
2
If the parking brake is in manual
mode, set the parking brake.
(P.184)
3
Shift the shift position to P.
(P.173)
Check that the shift position indicator
shows P. (P.172)
4
Press the engine switch.
The engine will stop, and the meter display
will be extinguished (the shift position indi-
cator will be extinguished a few seconds
after the meter display).
5
Check that "ACCESSORY" or
"IGNITION ON" is not shown on
the meter.
■
Automatic P position selection function
P.173
WARNING
■
Stopping the engine in an emergency
If you want to stop the engine in an
●
emergency while driving the vehicle,
press and hold the engine switch for
more than 2 seconds, or press it briefly
3 times or more in succession.
(P.374)
However, do not touch the engine
switch while driving except in an emer-
gency. Turning the engine off while
driving will not cause loss of steering
or braking control, however, power
assist to the steering will be lost. This
will make it more difficult to steer
smoothly, so you should pull over and
stop the vehicle as soon as it is safe to
do so.
4-2. Driving procedures
●
If the engine switch is operated while
the vehicle is running, a warning mes-
sage is shown on the multi-information
display and a buzzer sounds.
●
When restarting the engine after an
emergency shutdown, press the
engine switch.
Changing engine switch modes
Modes can be changed by pressing
the engine switch with the brake pedal
released. (The mode changes each
time the switch is pressed.)
1
Off
The emergency flashers can be used.
2
ACCESSORY mode
Some electrical components such as the
audio system can be used.
"ACCESSORY" will be displayed on the
meter.
3
IGNITION ON mode
All electrical components can be used.
163
4