Table of Contents
Advertisement
234
4-5. Using the driving support systems
If the cruise control main switch is pressed
and held for 1.5 seconds or more, the sys-
tem turns on in constant speed control
mode. (P.236)
2
Accelerate or decelerate, with
accelerator pedal operation, to the
desired vehicle speed (at or above
approximately 50 km/h [30 mph])
and press the "-SET" switch to set
the speed.
Cruise control "SET" indicator will come
on.
The vehicle speed at the moment the
switch is released becomes the set speed.
If the switch is operated while the vehicle
speed is below approximately 50 km/h
(30 mph) and a preceding vehicle is pres-
ent, the set speed will be adjusted to
approximately 50 km/h (30 mph).
Adjusting the set speed
To change the set speed, operate the
"+RES" or "-SET" switch until the
desired set speed is displayed.
1
Increases the speed
(Except when the vehicle has been
stopped by system control in vehi-
cle-to-vehicle distance control
mode)
2
Decreases the speed
Fine adjustment: Press the switch.
Large adjustment: Press and hold the
switch to change the speed, and release
when the desired speed is reached.
In the vehicle-to-vehicle distance con-
trol mode, the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*2
mph (1.6 km/h)
each time the switch is
pressed
Large adjustment: Increases or decreases
*1
in 5 km/h (3.1 mph)
or 5 mph (8 km/h)
increments for as long as the switch is held
In the constant speed control mode
(P.236), the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*2
mph (1.6 km/h)
each time the switch is
pressed
Large adjustment: The speed will continue
to change while the switch is held.
*1
or 1
*2
*1
or 1
Advertisement
Table of Contents
