Table of Contents
Advertisement
Immediately after the switch is pressed, the
radar cruise control indicator will come on.
Afterwards, it switches to the cruise con-
trol indicator.
Switching to constant speed control mode
is only possible when operating the switch
with the cruise control off.
2
Accelerate or decelerate, with
accelerator pedal operation, to the
desired vehicle speed (at or above
approximately 40 km/h [25 mph])
and press the "-SET" switch to set
the speed.
Cruise control "SET" indicator will come
on.
The vehicle speed at the moment the
switch is released becomes the set speed.
Adjusting the speed setting: P.234
Canceling and resuming the speed setting:
P.236
Dynamic radar cruise control with full-
■
speed range can be set when
●
The shift position is in D.
4-5. Using the driving support systems
LC500: Range 4 or higher of D has been
●
selected by using the paddle shift switch.
●
Vehicle speed is at or above approxi-
mately 50 km/h (30 mph).
However, when a preceding vehicle is
detected, the dynamic radar cruise con-
trol with full-speed range can be set even
if the vehicle speed is below approxi-
mately 50 km/h (30 mph).
Accelerating after setting the vehicle
■
speed
The vehicle can accelerate by operating the
accelerator pedal. After accelerating, the
set speed resumes. However, during vehi-
cle-to-vehicle distance control mode, the
vehicle speed may decrease below the set
speed in order to maintain the distance to
the preceding vehicle.
When the vehicle stops while follow-up
■
cruising
●
Pressing the "+RES" switch while the
vehicle ahead stops will resume follow-up
cruising if the vehicle ahead starts off
within approximately 3 seconds after the
switch is pressed.
●
If the vehicle ahead starts off within 3 sec-
onds after your vehicle stops, follow-up
cruising will be resumed.
Automatic cancelation of vehicle-to-
■
vehicle distance control mode
Vehicle-to-vehicle distance control mode is
automatically canceled in the following situ-
ations.
Actual vehicle speed falls at or below
●
approximately 40 km/h (25 mph) when
there are no vehicles ahead.
●
The preceding vehicle leaves the lane
when your vehicle is following at a vehicle
speed at or below approximately 40
km/h (25 mph). Otherwise, the sensor
can not properly detect the vehicle.
("CRUISE NOT AVAILABLE No Pre-
ceding Vehicles" is displayed on the
multi-information display)
VSC is activated.
●
●
TRC is activated for a period of time.
●
When the VSC or TRC system is turned
237
4
Advertisement
Table of Contents
