Table of Contents
Advertisement
164
4-2. Driving procedures
"IGNITION ON" will be displayed on the
meter.
Auto power off function
■
If the vehicle is left in ACCESSORY mode
for more than 20 minutes or IGNITION
ON mode (the engine is not running) for
more than an hour with the shift position in
P, the engine switch will automatically turn
off. However, this function cannot entirely
prevent the 12-volt battery discharge. Do
not leave the vehicle with the engine switch
in ACCESSORY or IGNITION ON mode
for long periods of time when the engine is
not running.
When the shift control system malfunc-
■
tions
When attempting to turn the engine switch
off while there is a malfunction in the shift
control system, the engine switch mode
may change to ACCESSORY mode. In this
case, ACCESSORY mode may be turned
off by applying the parking brake and press-
ing the engine switch again. If there is a mal-
function in the system, have the vehicle
inspected by your Lexus dealer immedi-
ately.
NOTICE
To prevent 12-volt battery discharge
■
●
Do not leave the engine switch in
ACCESSORY or IGNITION ON
mode for long periods of time without
the engine running.
If "ACCESSORY" or "IGNITION
●
ON" is displayed on the meter, the
engine switch is not off. Exit the vehicle
after turning the engine switch off.
Power (ignition) switch
(LC500h)
Performing the following opera-
tions when carrying the electronic
key on your person starts the hybrid
system or changes power switch
modes.
Starting the hybrid system
1
Press the parking brake switch to
check that the parking brake is set.
(P.184)
Parking brake indicator will come on.
2
Firmly depress the brake pedal.
and a message will be displayed on
the multi-information display.
If it is not displayed, the hybrid system can-
not be started.
When the shift position is N, the hybrid sys-
tem cannot start. Shift the shift position to P
when starting the hybrid system. (P.178)
3
Press the power switch shortly and
firmly.
When operating the power switch, one
short, firm press is enough. It is not neces-
sary to press and hold the switch.
If the "READY" indicator turns on, the
hybrid system will operate normally.
Continue depressing the brake pedal until
the "READY" indicator is illuminated.
The hybrid system can be started from any
Advertisement
Table of Contents
