Table of Contents
Advertisement
8. Carefully position the new front panel board so that the two screw holes in the new front panel board
are aligned with the corresponding mounting studs on the chassis. Then, install the screws to secure
the front panel board in place.
Figure 107. Installing the front panel board
9. Connect the front-panel-board cables to the system board. See "System board components" on
page 33.
10. If you are instructed to return the old front panel board, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 142.
Replacing the front VGA and USB module
your
page
and
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
To replace the front VGA and USB module, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. Prepare your server. See "Removing or extending the server from the rack cabinet" on page 57.
3. Remove the server cover. See "Removing the server cover" on page 57.
page
eading and
Chapter 6
131
.
Replacing hardware
Advertisement
Table of Contents
Troubleshooting
