Lenovo ThinkServer RD350G User Manual And Hardware Maintenance Manual page 125

3. Pull the handle and carefully slide the hot-swap hard disk drive or the dummy tray out of the front of
the chassis.
Figure 78. Removing the hot-swap hard disk drive or the dummy tray
4. Touch the static-protective package that contains the new hot-swap hard disk drive to any unpainted
surface on the outside of the server. Then, take the new hot-swap hard disk drive out of the package.
Note: Do not touch the circuit board on the hard disk drive.
5. Slide the new hot-swap hard disk drive into the drive bay from the front until it snaps into position
and then completely close the handle.
Figure 79. Installing the hot-swap hard disk drive
6. Check the hot-swap hard-disk-drive status LEDs to ensure that the hard disk drive is operating correctly.
You might have to restart the server for the newly installed hard disk drive to be recognized. See
"Hot-swap-drive status LEDs" on page 38. If the hard disk drive is faulty, you need to reinstall or
replace it until it is operating correctly.
7. Do one of the following:
.
Chapter 6 Replacing hardware
111