Lenovo ThinkServer RD350G User Manual And Hardware Maintenance Manual page 119

12. Close the microprocessor retainer. Close the small handle
lock the retainer into position and secure the new microprocessor in the socket.
Note: There are two marks on the microprocessor retainer. Ensure that you close the small handle
marked with first and then close the small handle marked with
when you close the small handles.
Figure 71. Securing the microprocessor in the socket
13. Use a cleaning pad to wipe the thermal grease from the removed heat sink. Dispose of the cleaning
pad after all of the thermal grease is removed.
14. Use one of the following methods to apply appropriate amount of thermal grease to the top of the
newly installed microprocessor in the shape of a cross or a circle as shown. Either too much or too
less application of thermal grease can cause a thermal problem due to imperfect contact with the
components.
Notes:
• Do not touch the thermal grease.
• Keep the thermal grease off the system board.
Figure 72. Applying the thermal grease to the top of the microprocessor
15. Reinstall the heat sink. See "Installing or replacing a heat sink" on page 95.
16. If you are instructed to return the old microprocessor, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
1
first. Then, close the small handle
. Always follow the correct sequence
.
Chapter 6 Replacing hardware
2
to
105