Generic Elements - Siemens SINUMERIK 840D sl Commissioning Manual

● As a shortened form, alternatives can also be written in square brackets:
● Options that begin with '-' can always be entered in any order.
3.3

Generic elements

Overview
This sections describes the syntax elements that are used by several actions.
Permitted interface designations
The names of network interfaces are used by "sc show ip", "sc set ip" and "sc enable
DHCPSvr", for example.
As the input of an interface is optional, it is always introduced by a '−' character. The '−' is
followed by the actual name. In most cases, multiple names are possible for the same
interface.
Accepted names are:
System network port:
Company network
port:
IBN port:
Permitted subsystem designations
Subsystem names are entered when using "sc enable" and "sc start", for example. In most
cases, the name of the subsystem is simply the name of the corresponding CFS, without the
path and without the extension ".cfs". For example, for the CFS /siemens/sinumerik/nck.cfs,
the relevant subsystem name is simply "nck".
It is also possible to use absolute paths (beginning with /) in a subsystem name. In the
example above, you could also use "/siemens/sinumerik/nck" as a subsystem name. The
difference between names with and without a specified path is that without the path, all CFS
with this name are included, but if the path is specified, only this exact CFS is meant.
NCU Operating System (IM7)
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
sc save [-full|-user] ...
Here you can use the option "-full" or "-user", or none at all.
For example, the notation could be interpreted to mean that "-force" must come after "-
full" or "-user", but this is not necessarily the case:
sc save [-full|-user] [-force] FILENAME
"X120", "eth2", "tcu", "internal"
"X130", "eth1", "factory", "extern
"X127", "ibn0", "pg"
Service Commands
3.3 Generic elements
23