Siemens SINUMERIK 840D sl Commissioning Manual page 58

Customizing the "Machine" operating area
6.2 Configuring the display of the G-code groups
Structure of the file
[Selected G-Groups]
SelectedGGroup1 = 1
SelectedGGroup2 = 2
SelectedGGroup3 = 3
SelectedGGroup4 = 4
SelectedGGroup5 = 5
SelectedGGroup6 = 6
SelectedGGroup7 = 7
SelectedGGroup8 = 8
SelectedGGroup9 = 9
SelectedGGroup10 = 11
SelectedGGroup12 = 12
SelectedGGroup13 = 13
SelectedGGroup14 = 14
SelectedGGroup15 = 15
SelectedGGroup16 = 16
[Selected G-Groups ISO-Mode]
... (as with section for Siemens)
The "Selected G Groups" area is intended for operating the controller in Siemens mode.
The "Selected G Groups ISO Mode" area is intended for operating the controller in ISO
mode.
Proceed as follows
1. Copy the "sl_window_g_code.ini" file from the following folder:
/Siemens/sinumerik/hmi/cfg
2. Paste the file into the following folder:
/User/sinumerik/hmi/cfg
As soon as the file is located in the user-specific folder (e.g. user or oem), the entries for
this file take precedence over the Siemens file. If an entry is missing in a user-specific file,
the corresponding entry from the Siemens file is used instead.
3. Open the file and enter the number of the G code in question at the required position
"SelectedGGroup1 = 5".
I.e. the 5th G-code group will be displayed at the 1st position.
52
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
HMI sl (IM9)