Siemens SINUMERIK 840D sl Commissioning Manual page 81

Entries
DecimalPlaces
Example
Only enter the modified data.
Configuring a new list parameter based on an existing list parameter.
If you are configuring a new parameter based on an existing list parameter, you must make
the following entries:
Entries
Base
Example
HMI sl (IM9)
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
Meaning
Number of decimal places if "DoubleMode" or "UnsignedDoubleMode" is
selected in DisplayMode.
See example: 2 decimal places are entered.
Meaning
Assign new parameter name
See example: "NewGeoRadius" text
Name of the parameter on which the new parameter is based.
See example: "GeoRadius" parameter is used as a template.
Only enter the modified data. All other data is taken from the existing parameter.
See example: Column width changed to 46 pixels. Number of decimal places
changed to 1.
Configuring tool management
9.4 Configure the list parameters
75