Configure The List Parameters - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring tool management

9.4 Configure the list parameters

9.4 Configure the list parameters
In the <PARAMETERCONFIGURATION> tag, you have the following options:
1. Change list parameters.
2. Create a new list parameter based on an existing list parameter.
Changing list parameters
You can change all the parameters included in the system.
See
Tool parameter identifiers (Page 70)
Cutting parameter identifiers (Page 71)
Monitoring parameter identifiers (Page 72)
Magazine location parameter identifiers (Page 73)
In the following example, the <GeoRadius> parameter is used.
Entries
HeadLine
ToolTip
ShortText
Width
DisplayMode
74
Meaning
Column header. Text entered is displayed as a header.
Example: Text "Radius" is displayed as a header (default).
Text that is displayed in the tooltip.
Example: Text "Geometry radius" is displayed in the tooltip (default).
Text if the parameter is displayed in the "More data" window.
Example: Text "Rad." is displayed in the "More data" window (default).
Column width in pixels, in relation to a 640 x 480 resolution.
See example below: The default column width is changed to 53 pixels.
Values that the parameter is displayed with.
See example below: The default setting is changed to "DoubleMode".
The following values can also be accepted:
AnyMode
IntegerMode
UnsignedIntegerMode
DoubleMode
UnsignedDoubleMode
Length
Angle
LinearFeedPerTime
LinearFeedPerRevolution
LinearFeedPerTooth
RevolutionSpeed
ConstantCuttingSpeed
All characters
Integers
Unsigned integers
Values with decimal places.
The number of decimal places is specified in
"DecimalPlaces".
Unsigned values with decimal places.
The number of decimal places is specified in
"DecimalPlaces".
Specified length
Specified angle
Linear feed in mm/minute
Linear feed in mm/revolution
Linear feed in mm/tooth
Speed controller
Constant cutting speed
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
HMI sl (IM9)