Siemens SINUMERIK 840D sl Commissioning Manual page 98

Configuring alarms
10.1 Creating alarm texts
Standard parameter specifications
The following table shows the standard parameter specifications:
Table 10-1
Parameter
specifier
%1
%2
%3
%4
%5
%6
%7
%8
%9
%0
%Z
%A
%K
%N
92
Standard parameter specifications
Description
First parameter from the alarm data of the alarm source
Second parameter from the alarm data of the alarm source
Third parameter from the alarm data of the alarm source
Fourth parameter from the alarm data of the alarm source
Fifth parameter from the alarm data of the alarm source
Only for NCK alarms
First part (up to the separator) of the fourth parameter from the alarm data of the
alarm source
Sixth parameter from the alarm data of the alarm source
Only for NCK alarms
Second part (between the first and second separator) of the fourth parameter from
the alarm data of the alarm source
Seventh parameter from the alarm data of the alarm source
Only for NCK alarms
Third part (between the second and third separator) of the fourth parameter from the
alarm data of the alarm source
Eighth parameter from the alarm data of the alarm source
Only for NCK alarms
Fourth part (between the third and fourth separator) of the fourth parameter from the
alarm data of the alarm source
Ninth parameter from the alarm data of the alarm source
Tenth parameter from the alarm data of the alarm source
Specially for PLC alarms:
like %1, for S7-HiGraph alarms, the step number of the graph is displayed
Specially for PLC alarms:
Third and fourth places of the decimal Alarm-ID: 123456, corresponds to the axis
number
Specially for PLC alarms:
Fifth and sixth places of the decimal Alarm-ID: 123456, corresponds to the channel
number
Specially for PLC alarms:
First and second places of the decimal Alarm-ID: 123456, corresponds to the signal
number
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
HMI sl (IM9)