Mitsubishi Evolution EVOMITS Original Instructions Manual page 211

Fig 7
Fig 8
• Adjust as necessary.
• When the level is correct tighten the Oil Filler/Level Cap
securely into the engine casing
Note: Change the oil according to the Maintenance Summary
Chart (Refer also to MAINTENANCE – Engine oil replacement )
5. Connecting an accessory
Your EVO-SYSTEM Engine has a unique coupling that enables
a variety of Evolution accessories to be connected to and be
driven by this machine. This coupling is engineered to very
fine tolerances and must be kept clean and free from dirt,
debris etc.
A cover for coupling protection is provided with each accessory
and should be used whenever the accessory is 'remote' from
the engine.
If you experience difficulty in accessory connection, it could
be because the accessory location pins, or the annuli of either
the accessory or the engine are contaminated or damaged.
Refer to the MAINTENANCE section 5 which gives details
of how to clean the annuli mating rings and the accessory
locating pins.
Note: The EVO-SYSTEM Engine has a micro switch
incorporated within the coupling design that senses
when an accessory has been successfully attached to the
machine. The engine will not start without an accessory
being connected. It cannot be run as a 'stand alone'
machine.
• Lock the Transportation Wheels using the wheel brake.
(Fig. 7)
• Release the Accessory Mounting Frame by rotating the
locking levers to their unlocked (down) position and push-in.
• Deploy the Accessory Mounting Frame. (Fig. 8)
Note: It is important that the frame is correctly deployed for
successful accessory connection.
• Lock the frame into position by pulling out and returning
the locking levers to their locked (upright) position.
Note: Each accessory is equipped with 3 locating pins, and 2
rear stabilising pins. The 3 locating pins lock into the
'Uni-coupling' the 2 stabilising pins slide into the sockets in
the Accessory Mounting Frame.
• Hold the accessory by its external frame and offer it up
to the engine. Visually align the 3 locating pins and 2 rear
stabilising pins. (Fig. 9) Enlist competent help if necessary.
The generator in particular is heavy and help with lifting
may be required.
www.evolutionpowertools.com
CZ
®
DA
DE
EL
ES
FI
FR
GB
IT
NL
NO
PL
PT
RU
SK
SV
211