Step 9: Power On The Ptx5000; Power On A Ptx5000 With 60-A Dc Pdus - Juniper PTX5000 Quick Start Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

Step 9: Power On the PTX5000

IN THIS SECTION

Power On a PTX5000 with 120-A DC PDUs | 64

Power On a PTX5000 with High Capacity DC PDUs | 66

Power On a PTX5000 with Three-Phase AC PDUs | 68

Power On a PTX5000 with High Capacity Single-Phase AC PDUs | 69

Depending on the type of PDUs you have installed, perform the appropriate procedure:

Power On a PTX5000 with 60-A DC PDUs

To power on the DC-powered PTX5000 with 60-A DC PDUs and 60-A DC PSMs:

NOTE:

After powering off a power supply, you must wait at least 60 seconds before powering it

on again.

1. Verify that the power distribution units (PDUs) and power supply modules (PSMs) are fully inserted in

the chassis and that the captive screws on the faceplates are tightened.

2. Verify that an external management device is connected to one of the Routing Engine ports on the

Control Board (AUXILIARY or CONSOLE).

NOTE:

The management Ethernet port labeled HOST/ETHERNET on the Control Board is not

available until after the initial software configuration. You can monitor the startup process during

the initial installation using devices connected to the AUXILIARY or CONSOLE ports.

3. Turn on power to the external management device.

Table of Contents