Juniper PTX5000 Quick Start Manual page 49

Figure 42: Attaching the Power Cord to the High Capacity Delta AC PDU
7. Connect the wires to the AC terminal block on the High Capacity Delta AC PDU
Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen each of the input terminal screws and the grounding
point screw, insert each wire into the grounding point or input terminal, and tighten the screw.
a. Insert the wire labeled GND into the grounding point.
b. Insert the wire labeled L1 into the L1 input terminal.
c. Insert the wire labeled L2 into the L2 input terminal.
d. Insert the wire labeled L3 into the L3 input terminal.
(Figure 43 on page 50).
49