Juniper PTX5000 Quick Start Manual page 38

Figure 29: Removing the Retaining Nut from a Three-Phase Wye AC Power Cord
1 1
1 Retaining nut
—
5. Put the wires of the AC power cord through the hole of the metal retaining bracket, and screw the
retaining nut onto the AC power cord to secure it to the metal retaining bracket (see
Figure 30 on page 38).
Figure 30: Connecting the Metal Retaining Bracket to the Three-Phase Wye AC Power Cord
1 1
2
1 Retaining nut
—
2 Metal retaining bracket
—
6. Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal AC wiring
compartment. Open the metal door of the metal AC wiring compartment. Push the wires of the AC
power cord into the area for the metal retaining bracket, and pull the wires to the left toward the metal
AC wiring compartment. Using a number 2 Phillips (+) screwdriver, use the four captive screws on the
metal retaining bracket to secure the AC power cord to the PDU (see
2
2 Three-phase wye AC power cord
—
3
3 Three-phase wye AC power cord
—
Figure 31 on page 39).
38