Juniper PTX5000 Quick Start Manual page 55

7. Attach the power cord to the PDU:
a. Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal AC wiring
compartment.
b. Open the metal door of the metal AC wiring compartment.
c. Push the wires of the AC power cord into the area for the metal retaining bracket, and pull the wires
to the left toward the metal AC wiring compartment.
d. Using a number 2 Phillips (+) screwdriver, use the four captive screws on the metal retaining bracket
to secure the AC power cord to the PDU (see
Figure 50: Connecting Power to a High Capacity Wye AC PDU
8. Connect the wires to the AC terminal block on the High Capacity Wye AC PDU (see
Figure 51 on page 56). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen each of the input terminal
screws and the grounding point screw, insert each wire into the grounding point or input terminal, and
tighten the screw.
a. Insert the neutral wire labeled GND into the grounding point.
b. Insert the wire labeled L1 into the L1 input terminal.
c. Insert the wire labeled L2 into the L2 input terminal.
d. Insert the wire labeled L3 into the L3 input terminal.
e. Insert the wire labeled N into the N input terminal.
Figure 50 on page 55).
55