Juniper PTX5000 Quick Start Manual page 67

NOTE: After a PDU is powered on, it can take up to 60 seconds for status indicators—such as
the LEDs on the PDU and PSMs, the command output displays, and messages on the LCD
display on the craft interface—to indicate that the PDU and PSMs are functioning normally.
Ignore error indicators that appear during the first 60 seconds.
NOTE: If the PDU OK and PSM LEDs do not light steadily or if the fault (
is lit, see Troubleshooting the PTX5000 Power System in the
Hardware Guide.
9. On the external management device connected to the Routing Engine, monitor the startup process to
verify that the system has booted properly.
10. Repeat Step 6 through Step
NOTE: The Routing Engine boots as the PDU completes its startup sequence. If the Routing Engine
finishes booting and you need to power off the system, see the Powering Off the PTX5000 in the
PTX5000 Packet Transport Router Hardware
After powering on a power supply, you must wait at least 60 seconds before powering it off.
8 for the other PDU.
Guide.
) LED on the PSM
PTX5000 Packet Transport Router
67