Juniper PTX5000 Quick Start Manual page 47

Figure 39: Removing the Retaining Nut from an AC Power Cord
1 1
1 Retaining nut
—
5. Put the wires of the AC power cord through the hole of the metal retaining bracket, and screw the
retaining nut onto the AC power cord to secure it to the metal retaining bracket (see
Figure 40 on page 47).
Figure 40: Connecting the Metal Retaining Bracket to an AC Power Cord
NOTE: If you are using 150 A power, you must use a metal bracket that is larger than the default
metal bracket. This bracket is shipped along with the High Capacity Delta AC PDUs. Labels on
top of the metal brackets specify the power cords that can be used for each bracket (see
Figure 41 on page
the same for both metal brackets.
2
48). The installation procedure to connect the metal bracket to the PDU is
2 AC power cord
—
47