Juniper MX960 Hardware Manual page 455

6. Place one hand around the front of the AS MLC (the modular card housing) and the other hand under
it to support it. Slide the AS MLC completely out of the chassis, and place it on the antistatic mat or in
the electrostatic bag.
CAUTION:
prepared to accept the full weight—up to 15.27 lb (6.93 kg)—as you slide the
AS MLC out of the chassis.
When the AS MLC is out of the chassis, do not hold it by the ejector handles,
bus bars, or edge connectors. They cannot support its weight.
Do not stack AS MLCs on top of one another after removal. Place each one
individually in an electrostatic bag or on its own antistatic mat on a flat, stable
surface.
7. If necessary, remove each installed AS MSC and AS MXC from the AS MLC.
8. After you remove each modular card, immediately place it on an antistatic mat or in an electrostatic
bag.
9. If you are not reinstalling an AS MLC into the emptied slots within a short time, install a blank AS MLC
panel over each slot to maintain proper airflow in the card cage.
CAUTION:
before reinserting it or inserting an AS MLC into a different slot.
The weight of the AS MLC is concentrated in the back end. Be
After removing an AS MLC from the chassis, wait at least 30 seconds
442