Juniper MX960 Hardware Manual page 360

9. Route the positive and negative DC power cables through the left and right sides of the cable restraint.
10. Tighten the cable restraint captive screw to hold the power cables in place.
11. Replace the clear plastic cover over the terminal studs on the faceplate.
12. Verify that the power cables are connected correctly, that they are not touching or blocking access to
router components, and that they do not drape where people could trip on them.
13. Repeat Steps 3 through
Figure 116: Connecting DC Power to the MX960 Router
RELATED DOCUMENTATION
DC Power Cable Specifications for the MX960 Router | 243
Preventing Electrostatic Discharge Damage to an MX960 Router
Powering On a DC-Powered MX960 Router with Normal Capacity Power Supplies | 350
12 for the remaining power supplies.
345