Installing or removing the internal PVIM module on the
Secure Router 2330
Use the instructions in this section to install, remove, or replace the internal PVIM module on
the Secure Router 2330. This internal module is not hot swappable.
If you ordered the PVIM module with your Secure Router 2330, the Secure Router ships with
the PVIM module installed. The estimated average time to install the internal PVIM module is
fifteen minutes.
Caution:
Do not open the Secure Router 2330 top cover while the unit is powered.
Installing the internal PVIM module
Use the procedure in this section to install an internal PVIM module. If you are replacing a
PVIM module, also see
Prerequisites
• Ensure you have a PVIM module ready to install before opening the chassis top cover.
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Secure Router 2330 is powered off.
Procedure steps
1. Remove the Secure Router 2330 top cover. For information, see
2. Locate the internal PVIM module connector slot.
Installation — Hardware Components
Installing or removing the internal PVIM module on the Secure Router 2330
Removing the internal PVIM module
Secure Router 2330 top cover
See the following figure for reference.
on page 90.
on page 86.
Removing the
August 2013
89