Removing The Internal Pvim Module - Avaya Secure Router 4134 Hardware Installation

Installing Avaya Secure Router 2330/4134 hardware components
3. Ensure the PVIM slot is clear of debris. Protective tape is placed over the SO-DIMM
and PVIM slots during the manufacturing process; remove this tape if it is
present.
4. Holding the PVIM by its edges, insert the module in the slot on the Main Board,
pushing down gently, but firmly, to fully seat the module. The release latches close
when the PVIM is properly installed.

Removing the internal PVIM module

Use the procedure in this section to remove a PVIM module from the Secure Router 2330.
Caution:
The internal PVIM module is not hot swappable. Do not open the Secure Router 2330 top
cover while the unit is powered.
Prerequisites
• Ensure you have a Phillips #1 screwdriver.
• Ensure the Secure Router 2330 is powered off.
• Ensure you have an antistatic bag or sheet available for the PVIM that you are
removing.
90 Installation — Hardware Components
Comments? infodev@avaya.com
August 2013