Installing A Dimm On The Mediation Server Module - Avaya Secure Router 4134 Hardware Installation

Installing or removing the DIMM on the Secure Router 4134 Mediation Server Module for OCS
Electrostatic alert:
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an electrostatic discharge (ESD) jack when performing maintenance on this
product. Ensure that the wrist strap makes contact with your skin.

Installing a DIMM on the Mediation Server Module

Use the procedure in this section if you must install a DIMM on the Mediation Server
Module.
Average time to install a DIMM on the Mediation Server Module: 3 minutes.
Prerequisites
• Ensure the Secure Router 4134 is powered down.
• Ensure you have a Phillips #2 screwdriver.
• Ensure you have antistatic material available on which to lay the Mediation Server Module
while you work.
• Ensure you have a DIMM ready to install before opening the service access panel.
Procedure steps
1. Using a Phillips screwdriver, loosen the two captive screws that secure the
2. Using the lever on the module, pull the module straight out of the chassis slot.
3. Ensure you place the Mediation Server Module on antistatic material if you lay it
Installation — Hardware Components
Mediation Server Module to the chassis. The following figure shows the screws.
Support the module as you remove it from the chassis by grasping it by the
edges.
down to install a DIMM.
Always hold the module by its edges.
August 2013 81