4. Grasping the edges of the VPN/IPSec module, pull the module up and out of the
5. If you are not installing a VPN/IPSec module at this time, replace the service access
Installing or removing an internal PVM on the Secure Router
4134
Use the instructions in this section to install, remove, or replace the internal Packetized Voice
Module (PVM). This internal module is not hot swappable.
Important:
You cannot enable the management port on the rear of the Secure Router 4134 (Ethernet
0/0) if you have a PVM installed (this is related to hardware design). Ensure you use Ethernet
0/1, 0/2, 0/3, or 0/4 for management if you use a PVM in the router.
If you ordered the PVM with your Secure Router 4134, the Secure Router ships with the PVM
installed.
Average time to replace the internal PVM module: 2 minutes.
Caution:
Do not open the Secure Router 4134 service access panel while the unit is powered.
Installation — Hardware Components
slot in which it is seated.
panel.
Installing or removing an internal PVM on the Secure Router 4134
August 2013
73