Replacing The Secure Router 2330 Internal Compact Flash - Avaya Secure Router 4134 Hardware Installation

Installing Avaya Secure Router 2330/4134 hardware components
Procedure steps
1. Remove the Secure Router 2330 top cover. For information, see
Secure Router 2330 top cover
2. Locate the internal DIMM module.
See the following figure for reference.
3. Release the latches that secure the DIMM in the slot.
There is a release latch at both ends of the DIMM slot.
4. Firmly grasp the DIMM by its edges and pull straight up to remove the DIMM from
the slot.
5. Insert the replacement DIMM in the slot, pushing down firmly but gently to fully seat
it in the slot.
The release latches close when the DIMM is properly installed.

Replacing the Secure Router 2330 internal Compact Flash

Use the instructions in this section if you must replace the internal Compact Flash on the
Secure Router 2330. This internal device is not hot swappable.
Caution:
The internal Compact Flash module is not hot swappable. Do not open the Secure Router
2330 top cover while the unit is powered.
92 Installation — Hardware Components
on page 86.
Comments? infodev@avaya.com
Removing the
August 2013