Replacing The Dimm In The Secure Router 4134 - Avaya Secure Router 4134 Hardware Installation

Replacing the DIMM in the Secure Router 4134

Use the instructions in this section if you must replace the DIMM. The DIMM is not hot
swappable.
Average time to replace a DIMM: 2 minutes.
Caution:
Do not open the Secure Router 4134 service access panel while the unit is powered.
Prerequisites
• Ensure the Secure Router 4134 is powered down.
• Ensure you have a replacement DIMM.
• Ensure you have a Phillips #2 screwdriver.
Procedure steps
1. Remove the two screws at the rear of the Secure Router 4134 that hold the service
access panel secure. The following figure shows the two screws that you must
remove.
2. Slowly slide the access panel toward you until it is clear of the Secure Router
4134.
3. Locate the DIMM module.
4. Release the latches that secure the DIMM in the slot. There is a release latch at
both ends of the DIMM slot. See the following figure.
Installation — Hardware Components
Replacing the DIMM in the Secure Router 4134
August 2013 79