6. Install the access panel onto the Secure Router 4134.
7. Install the two screws that secure the service access panel to the Secure Router
Removing the internal PVM
Use the procedure in this section to remove a PVM from the Secure Router 4134.
Average time to remove a PVM: 1 minute.
Caution:
The internal PVM is not hot swappable. Do not open the Secure Router 4134 service access
panel while the unit is powered.
Prerequisites
• Ensure the Secure Router 4134 has the power switched off.
• Ensure you have a Phillips #2 screwdriver.
• Ensure you have an antistatic bag or sheet available for the PVM that you are
removing.
Procedure steps
1. Remove the two screws at the rear of the Secure Router 4134 that hold the service
Installation — Hardware Components
4134.
access panel secure. Remove these two screws only. See the following figure.
Installing or removing an internal PVM on the Secure Router 4134
August 2013
77