Installing Avaya Secure Router 2330/4134 hardware components
Installing the internal PVM
Use the procedure in this section to install an internal PVM. If you are replacing a PVM, also
see
Removing the internal PVM
Average time to install the internal PVM module: 1 minute.
Prerequisites
• Ensure the Secure Router 4134 has the power switched off.
• Ensure you have a PVM ready to install before opening the service access panel.
• Ensure you have a Phillips #2 screwdriver.
Procedure steps
1. Remove the two screws at the rear of the Secure Router 4134 that hold the service
access panel secure. Remove these two screws only. See the following figure.
2. Slowly slide the access panel toward you until it is clear of the Secure Router
4134.
3. Locate the internal PVM connector slot. The following figure shows the location for
installing the PVM.
74
Installation — Hardware Components
on page 77.
Comments? infodev@avaya.com
August 2013