Chapter 5: Installing Avaya Secure Router 2330/4134 Hardware Components; Installing The Interface Modules - Avaya Secure Router 4134 Hardware Installation

Chapter 5: Installing Avaya Secure Router
The Avaya Secure Router 4134 ships with the fan tray installed, as well as the power supply unit or units
that you ordered. This section contains instructions for installing hardware components, as well as
instructions for replacing a fan tray, power supply unit, and internal components.

Installing the interface modules

You install the optional interface modules in the front panel of the Secure Router 2330/4134
chassis.
Avaya strongly recommends that you power down the Secure Router 2330/4134 if you are
installing an interface module in a slot in which you have not previously installed that module
type. If you do not power down the router to install a module, you must reboot the router to use
the module. After a module is installed and initialized, you can hot swap that module. For more
information about the Secure Router 4134 hot swap capabilities, see
Router 4134 hardware components
interface modules
The chassis has horizontal slots for small, medium, and large interface modules. The chassis
ships with four small slots, and three medium slots. You can adapt two of the medium slots to
accommodate a large module (which spans two medium slots). You must order modules
separately.
The following figure shows the default slot configuration and indicates how slots are numbered
on the Secure Router 4134.
Installation — Hardware Components
2330/4134 hardware
components
on page 51. To hot swap modules, see
on page 60.
Hot swapping Secure
Hot swapping
August 2013 55