Installing Or Replacing A Secure Router 4134 Power Supply Module - Avaya Secure Router 4134 Hardware Installation

To access the command line interface (CLI) using the rear panel console port, connect a
terminal or a workstation running terminal emulation software to the Secure Router 2330/4134
using the console cable that ships with the unit.
Average time to connect the console port cable to a local terminal: 1 minute.
Prerequisites
• Ensure you have the supplied console cable ready to install.
• Ensure you have the supplied female DB-9 to RJ-45 adapter if you require it for connection
to your terminal or PC.
• Ensure you have the Secure Router 2330/4134 securely installed in the equipment
rack.
Procedure steps
1. Insert the male RJ-45 connector in the console port of the Secure Router
2. Connect the female DB-9 to RJ-45 adapter to the opposite end of the console cable,
3. Insert the RJ-45 or female DB-9 connector (dependent on your equipment) in a
Installing or replacing a Secure Router 4134 power supply
module
Important:
This procedure does not apply to the Secure Router 2330.
The Secure Router 4134 operates with one or two AC power supply modules, one or two DC
power supply modules, or one AC and one DC power supply module. You install the power
supply modules at the rear of the unit.
Installation — Hardware Components
2330/4134.
if necessary.
terminal or PC.

Installing or replacing a Secure Router 4134 power supply module

August 2013 67