Juniper E Series Hardware Manual page 107

Figure 43: SODIMM sockets on the SRP-5 and SRP-10 module
Figure 44: SODIMM sockets on the SRP-40 module
2. Insert a SODIMM from the upgrade kit at an angle of approximately 45 degrees
3. Press the top surface downward into the socket until the socket spring snaps
4. Repeat steps 2 through 3 with the other SODIMM.
5. Repeat steps 1 through 4 for the other SRP module, if present.
Cream ceramic connector
Empty SODIMM socket
SODIMM
Empty SODIMM socket
SODIMM
into an empty ceramic connector, so that the notch in the long gold edge of the
SODIMM aligns with the notch in the connector.
The notch on the long gold edge will no longer be visible when the SODIMM is
pressed in far enough.
into place and holds it.
Chapter 9: Maintaining E-series Routers
1. Align notches in
SODIMM and connector.
2. Push SODIMM into
connector at an angle of
approximately 45 degrees.
3. Push down on back edge
of SODIMM until it snaps
NVS card
into socket.
Upgrading Memory on SRP Modules
! 89