Erx-7Xx Models - Juniper E Series Hardware Manual

Figure 5: ERX-14xx model, rear view

ERX-7xx Models

NOTE:
ERX-705 router and the ERX-710 router. The terms ERX-705 router and ERX-710
router refer to the specific models. See Figure 6 and Figure 7.
The ERX-7xx models are robust, high-density routers with less capacity than the
ERX-14xx models. The ERX-7xx models use either the SRP-10G module or the
SRP-5G module.
You can configure the ERX-7xx models to enable the line modules to operate either
at full line rate performance or at a rate dependent on the resources available. For
information about configuring performance of line modules, see
Basics Configuration Guide, Chapter 5, Managing Line Modules and SRP
NOTE:
10-Gbps SRP module used in the ERX-710 router. See section
this chapter, for more information.
Fan tray
I/O
module
SRP I/O
module
Power input
module
Cable
management
bracket
Plenum
In the E-series documentation, the term ERX-7xx models refers to both the
The 10-Gbps SRP module used in the ERX-310 router is different from the
Chapter 1: E-series Overview
JUNOSe System
Modules.
SRP Module, later in
E-series Routers
! 7