Juniper E Series Hardware Manual page 80

E-series Hardware Guide
62 !
Cabling the E-series Router for Power
Table 9: Power input module cables/wires needed
Cable/Wire
ERX-14xx models
One 10-AWG ground wire
Two 6-AWG wire leads
Two 6-AWG wire leads
ERX-7xx models
One 10-AWG ground wire
Two 10-AWG wire leads
Two 10-AWG wire leads
ERX-310 router
One 10-AWG ground wire
Two 14-AWG wire leads
DC model only
NOTE:
Two 14-AWG wire leads
NOTE: DC model only
One AC power cord
AC model only
NOTE:
From
Power input module ground
terminal
Power input module Power A
–48 VDC and RTN leads
Power input module Power B
–48 VDC and RTN leads
Power input module ground
terminal
Power input module Power A
–48 VDC and RTN leads
Power input module Power B
–48 VDC and RTN leads
Power input module ground
terminal
Power input module Power A
–48 VDC and RTN leads
Power input module Power B
–48 VDC and RTN leads
Power input module AC power IEC
receptacle
To
Termination ground
Appropriate leads on power
source No. 1
Appropriate leads on power
source No. 2
Termination ground
Appropriate leads on power
source No. 1
Appropriate leads on power
source No. 2
Termination ground
Appropriate leads on power
source No. 1
Appropriate leads on power
source No. 2
Appropriate AC power
supply