Task 6: Mount The Cd On The Network Host; Task 7: Copy The Software Release File; Task 8: Save The Current Configuration - Juniper E Series Hardware Manual

E-series Hardware Guide
180 !
Installing Software When a Firewall Does Not Exist
If the network host is listed, go to step 8. Otherwise, proceed with step 6.
6. Add an entry to the Static Host Table so that the E-series router can access the
network host. The host command allows you to specify the network host name
and IP address.
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#host hostName ipAddress ftp loginname password
7. Press <CTRL-Z> to return to Privileged Exec mode.
8. Use the ping command to determine whether the E-series router can now
reach the network host.
host1#ping hostname
If the E-series router cannot reach the network host, verify that you correctly
performed the previous steps in this procedure and that the network host is
operational.

Task 6: Mount the CD on the Network Host

The way you mount the CD on the network host depends on the type of network
host you use, the operating system, and the way your network is configured. To find
out how to mount a CD on the network host, review the manual for the operating
system, or check with your network administrator.

Task 7: Copy the Software Release File

To copy the software release file to the E-series router, use the copy command.
Be sure to specify the correct software release (.rel) filename for the router you are
using, as described in Identifying the Software Release
The destination file must have a .rel extension.
NOTE:
For example:
host1#copy hostname:/cdrom/x-y-z/erx_x-y-z.rel erx_x-y-z.rel
The software release is copied from the network host to the E-series router. This
process can take several minutes.

Task 8: Save the Current Configuration

To save the current configuration, use the copy running-configuration command:
host1#copy running-configuration filename.cnf
File.