2. With a small flathead screwdriver, remove the faceplate from the NVS card slot
3. Use the screwdriver to depress the button next to the NVS card (see Figure 42).
Figure 42: NVS card slot on SRP module
Faceplate
4. Remove the NVS card and place it in the antistatic container.
5. Insert the new NVS card into the slot.
6. Push the new NVS card as far as you can in the slot.
7. Replace the faceplate on the NVS card slot.
Upgrading Memory on SRP Modules
This section describes how to upgrade memory on SRP modules. E-series software
releases 3.0.x and higher require at least 512 MB of memory on each SRP module.
NOTE:
memory, and currently is not upgradeable.
Four main steps are involved in upgrading memory on SRP modules:
1. Check memory currently installed on the SRP module.
2. Remove the SRP module and the SODIMMs.
3. Add the new SODIMMs to the SRP module.
4. Reinstall the SRP module and verify the upgrade.
on the SRP module (see Figure 42).
This action releases the NVS card.
NVS card
When you push the card far enough, it will click into place.
The ERX-310 SRP module contains two SODIMM banks that use 256-MB
Chapter 9: Maintaining E-series Routers
Release button
Upgrading Memory on SRP Modules
!
87