Juniper E Series Hardware Manual page 67

Figure 26: Ejectors in the closed position

Opened
Œ
Closed
Œ
Closed

Opened
5. Carefully slide the module out of the chassis.
6. Place the module in its antistatic bag.
7. Cover the empty chassis slot with a blank faceplate, and tighten the faceplate's
captive screws using a Phillips screwdriver. Turn both screws several times
before tightening them completely.
If you remove an I/O module and not the corresponding line module, the line
module reboots. Its status becomes "inactive" when you issue the show version
command.
If you remove a line module and do not delete the corresponding configuration, the
status of the line module will be "not present" when you issue the show version
command.
Removing a Line Module, SRP Module, or SRP I/O Module
Chapter 5: Installing Modules
! 49