Juniper E Series Hardware Manual page 150

E-series Hardware Guide
Table 22: I/O module specifications (continued)
I/O Module
a
Label Type
FE
FE-2 Non-ASIC ERX-7xx models
I/O
FE-8 ASIC
I/O
GE
GE ASIC
I/O
b,c
SFP
GE ASIC
I/O
b,d
SFP
132 !
I/O Module Specifications
Model SRP Module
Compatibility Compatibility No. of Ports
SRP-5G
ERX-1410 router SRP-5G+
SRP-10G
ERX-7xx models SRP-5G+
ERX-14xx models SRP-10G
ERX-310 router SRP-40G
SRP-40G+
SRP-SE10G
ERX-7xx models SRP-5G+
ERX-14xx models SRP-10G
ERX-310 router SRP-40G
SRP-40G+
SRP-SE10G
ERX-7xx models SRP-5G+
ERX-14xx models SRP-10G
ERX-310 router SRP-40G
SRP-40G+
SRP-SE10G
Connector
Type
2 RJ-45
8 RJ-45
1 active LC full duplex
1 redundant
1 active LC full duplex
1 redundant
Cabling Specifications
!
For 10-Mbps operation, use
CAT 3, 4, or 5 UTP cable.
!
For 100-Mbps operation, use
only CAT 5 UTP cable.
!
The transmitted signal
complies with IEEE
802.3/802.3u for cable
lengths up to 100 m
(328 feet).
!
For 10-Mbps operation, use
CAT 3, 4, or 5 UTP cable.
!
For 100-Mbps operation, use
only CAT 5 UTP cable.
!
The transmitted signal
complies with IEEE
802.3/802.3u for cable
lengths up to 100 m
(328 feet).
!
Tx power:
!
min: –9.5 dBm
!
max: –4 dBm
!
Center wavelength: 850 nm
!
Rx input power:
!
min: –17 dBm
!
max: –3 dBm
!
Rated for 275 m (300 yards)
over 62.5-micron core cable
!
Rated for 550 m (601 yards)
over 50-micron core cable
!
Tx power:
!
min: –9.5 dBm
!
max: –3 dBm
!
Center wavelength: 1300 nm
!
Rx input power:
!
min: –20 dBm
!
max: –3 dBm
!
Rated for 10 km (6.2 miles)
over 10-micron core cable