E553-8012-02 Error In The Flapper Motor (Finisher-Aa1); E553-80F1-02 Error In The Saddle Feed/Paddle Motor (Finisher-Aa1); E553-80F2-02 Error In The Saddle Feed/Paddle Motor (Finisher-Aa1) - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

E553-8012-02
Detection Description
Remedy
E553-80F1-02
Detection Description
Remedy
E553-80F2-02
Detection Description
Remedy
Error in the Flapper Motor (Finisher-AA1)
The Flapper HP Sensor does not detect the flapper when the Flapper Motor has been driven for
1 second.
STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses from the Flapper HP Sensor (PS105) to the Finisher Controller PCB
- Harnesses from the Flapper Motor (M104) to the Finisher Controller PCB
- Flapper HP Sensor (PS105)
- Flapper Motor (M104)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
Error in the Saddle Feed/Paddle Motor (Finisher-AA1)
The paddle does not come off the Saddle Paddle HP Sensor when the Saddle Feed/Paddle Motor
has been driven for 1 second.
STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses from the Saddle Paddle HP Sensor (PS206) to the Saddle Stitcher Controller PCB
- Harnesses from the Saddle Feed/Paddle Motor (M201) to the Saddle Stitcher Controller PCB
- Saddle Paddle HP Sensor (PS206)
- Saddle Feed/Paddle Motor (M201)
- Saddle Stitcher Controller PCB (PCB201)
- Finisher Controller PCB (PCB101)
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
Error in the Saddle Feed/Paddle Motor (Finisher-AA1)
The Saddle Paddle HP Sensor does not detect the paddle when the Saddle Feed/Paddle Motor
has been driven for 1 second.
STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses from the Saddle Paddle HP Sensor (PS206) to the Saddle Stitcher Controller PCB
- Harnesses from the Saddle Feed/Paddle Motor (M201) to the Saddle Stitcher Controller PCB
- Saddle Paddle HP Sensor (PS206)
- Saddle Feed/Paddle Motor (M201)
- Saddle Stitcher Controller PCB (PCB201)
- Finisher Controller PCB (PCB101)
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
403
7. Error/Jam/Alarm