E537-8001-02: A. Front Alignment Motor Error (Finisher-K1) B. Rear Aligning Plate Hp Error (Finisher-Aa1); E537-8002-02: A. Front Alignment Motor Error (Finisher-K1) B. Rear Aligning Plate Hp Error (Finisher-Aa1) - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

E537-8001-02
Detection Description
Remedy
E537-8002-02
Detection Description
Remedy
a. Front Alignment Motor error (Finisher-K1) b. Rear Aligning Plate HP error (Finisher-AA1)
a. The Front Alignment Plate HP Sensor was not turned OFF although 1 second had passed after
the Front Alignment Motor operation started.
b. The rear aligning plate does not come off the Rear Aligning Plate HP Sensor although the Rear
Aligning Plate Motor has been driven for 4 seconds.
a. INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Motor
- Front Alignment Plate HP Sensor (PS4)
- Front Alignment Motor (M3)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate Motor
- Rear aligning plate drive mechanism
- Rear Aligning Plate HP Sensor (PI107)
- Rear Aligning Plate Motor (M104)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
a. Front Alignment Motor error (Finisher-K1) b. Rear Aligning Plate HP error (Finisher-AA1)
a. The Front Alignment Plate HP Sensor was not turned ON although 5 seconds had passed after
the Front Alignment Motor operation started.
b. The Rear Aligning Plate HP Sensor does not detect the rear aligning plate although the Rear
Aligning Plate Motor has been driven for 4 seconds.
a. INNER FIN-K1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Motor
- Front Alignment Plate HP Sensor (PS4)
- Front Alignment Motor (M3)
- Finisher Controller PCB (PCB1)
b. STAPLE FIN-AA1/BOOKLET FIN-AA1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate HP Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Rear Aligning Plate Motor
- Rear aligning plate drive mechanism
- Rear Aligning Plate HP Sensor (PI107)
- Rear Aligning Plate Motor (M104)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the corresponding harnesses/cables or connectors or the parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> Adjustment when
Replacing the Parts" in the Service Manual.
398
7. Error/Jam/Alarm